Hello Tello Pilot!
Join our DJI Tello community & remove this banner.
Sign up

Recent content by MrSEG

  1. M

    Motor driver IC(MosFET)-Type?

    Hi Nanda, the type of MosFET used by Tello is PMPB11EN Datasheet
  2. M

    Motor driver IC(MosFET)-Type?

    I've (re)soldered it with hot air. It works well. And not so difficult. Because the mosfets are placed on the edge of pcb and are good accessible by pincette. For removing of PCB i only desoldered the motors wires. And disconnected the cam connector. The plug of CAM is additionally attached...
  3. M

    Motor driver IC(MosFET)-Type?

    So, i've replaced the one defective mosfet (PMPB11EN) today. It works fine and my tello now flying again:cool: (y)like at its first day. You can try the replacement. It will maybe work also fine ..or not. The operatig areas of the both types (PMPB10XNE/PMPB11EN) are a little bit different...
  4. M

    Motor driver IC(MosFET)-Type?

    Hi, Yes, there are 4 mosfets of the same type. One for each motor. The exact pinout you can see in the datasheet of the mosfet. Drain is connected to the "-" pole of the Motor. I think the PMPB10XNE would also work. But I am not sure if the performance would increase significantly. I think...
  5. M

    Motor driver IC(MosFET)-Type?

    No, in my case is the MosFET dead. It has 1,5 kOhm between S(source) and D(drain). The good one has nearly infinite resistance. The resistance D/S can be simply tested by disconnected Motors between Motors "-" pole on board and GND.
  6. M

    Motor driver IC(MosFET)-Type?

    The motor starts to spinn if i switch Tello on. But not by setting the battery. I will check you method. I thik, i´v found the right type of MosFET. It is PMPB11EN. It has also the marking "1C". The package (SOT1220) and the other parameters seems to be rigth. I´v allready ordered a couple of...
  7. M

    Motor driver IC(MosFET)-Type?

    What is the exact type of MosFET is used for driving the Tello motors? The marking on the IC is "1C" and "W81" (s. photo) One of them is dead on my Tello, after i´v replaced the motor, which was damaged by crash before. Now i need to replace the IC, but i dont know, what exactly type i need.