Hello all,
I have connected 4 robomaster drones succesfully via the MIND+ program. The 5th robomaster wont connect for some reason.
I have tried:
1 Swap the open source controllers between the drones. All the other open source controllers work on the drone. So the drone is not the problem.
2 tried different routers, same goes here. The drone wont connect in team(router) mode.
3 I downloaded the robomaster assistant to check the firmware. But i dont get any further than the boot screen of this application.
Is there any way i can check if the open source controller is broken?
Thank you
I have connected 4 robomaster drones succesfully via the MIND+ program. The 5th robomaster wont connect for some reason.
I have tried:
1 Swap the open source controllers between the drones. All the other open source controllers work on the drone. So the drone is not the problem.
2 tried different routers, same goes here. The drone wont connect in team(router) mode.
3 I downloaded the robomaster assistant to check the firmware. But i dont get any further than the boot screen of this application.
Is there any way i can check if the open source controller is broken?
Thank you