- Joined
- Oct 5, 2018
- Messages
- 3
- Reaction score
- 0
I've played with the droneblocks code for an hour today and it just does not work. I'm using an iPad and the latest firmware/versions to perform takeoff/fly right20/yaw right90/fly forward20/flyleft20/land. All inches. It will not go left.
I can make a program that says takeoff/ flyleft20/land and all good. As I add blocks, one of them will refuse to work. I've used far to many combinations to list here (been at it for 1 hour) and I can't find a pattern. The 'failed' block will work in isoloation though. It's not just left, it could be any of the blocks.
Also, I tried cm and any distance in cm is way too short. If you make the distance as short as 20cm then the drone goes nowhere.
Any advice plz?
I can make a program that says takeoff/ flyleft20/land and all good. As I add blocks, one of them will refuse to work. I've used far to many combinations to list here (been at it for 1 hour) and I can't find a pattern. The 'failed' block will work in isoloation though. It's not just left, it could be any of the blocks.
Also, I tried cm and any distance in cm is way too short. If you make the distance as short as 20cm then the drone goes nowhere.
Any advice plz?
