Real FPV equipment and Tello Drone

[RxTx]

Hi!

I prepared a video in which I showed how we can use the FPV equipment for our Tello.

Do not take this video too serious, please

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[spamaro]

Hello,
Thank you for that share. I presume you used wifi extender for that demo ?

Here is a link of another discussion about FPV. There is interesting method too, where the camera is directly plugged on the tello battery (lastest messages) :
Tello + FPV camera.

 

[RxTx]

I presume you used wifi extender for that demo ?

No I didn't have a wifi extender. And that really limited me.
For a full flight I also lacked - Ryze Telo Gamesir T1d Controller.

Here is a link of another discussion about FPV. There is interesting method too, where the camera is directly plugged on the tello battery (lastest messages) : Tello + FPV camera.

Thank You!

It was interesting, because then the weight of the drone is not greatly increased.
But reduces flight time on one battery.
But a lot of weight does the same.

Maybe we can find a balance.
Or. ... connect two batteries into one

 

[Gjwja]

Hi!

I prepared a video in which I showed how we can use the FPV equipment for our Tello.

Do not take this video too serious, please

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Hi, looks interesting. As I also fly other drones, I have the cameras and googles. Where did you find the 3d bracket as I can not find it on thingverse.

Thanks,
George

 

[spamaro]

Hi, looks interesting. As I also fly other drones, I have the cameras and googles. Where did you find the 3d bracket as I can not find it on thingverse.

Thanks,
George

Hello,
The 3D model url is in the youtube video description : CAMERA HOLDER for Tello Drone by OKSANA3D

 

[RxTx]

Hello,
The 3D model url is in the youtube video description : CAMERA HOLDER for Tello Drone by OKSANA3D

spamaro, thanks You for the answer!

To assamble the whole construction we used glue under the camera objectiv to hold it tightly, because it is heating a lot during its work and the camera objectiv is the coldest place.
It is working pritty well without melted plastic effect:

 

[Gjwja]

thanks, I printed it out and will try .. I might try a product called GOOP to affix the camera

 

[RxTx]

thanks, I printed it out and will try .. I might try a product called GOOP to affix the camera

Cool!
We're waiting for your video!