Tello Fimeware 1.03.33.01

[f41ardu]

While playing with Phyton3 Tello3.py and my own Processing based software I identified that most of the commands
reported here are not supported by my Tello (its a non EDU). Is that an issue with my current Firmeware.
So i.e. temp?, baro? result in the message Unknow Command. Takeoff, land ccw back- and forward are working.

Thanks in advance
f41ardu

 

[Plissken]

While playing with Phyton3 Tello3.py and my own Processing based software I identified that most of the commands
reported here are not supported by my Tello (its a non EDU). Is that an issue with my current Firmeware.
So i.e. temp?, baro? result in the message Unknow Command. Takeoff, land ccw back- and forward are working.

Thanks in advance
f41ardu

Do u think this is a last firmware?!? Mine got a completely different number...

 

[f41ardu]

Do u think this is a last firmware?!? Mine got a completely different number...

I'm now on the latest available software (in my country)? Different by country, even the upgrade process?
But I also use now a different library (JTello) re-based to Processing and
everything works fine now. I haven't tested my own code yet. Will do that the upcoming weekend.

 

[Plissken]

I'm now on the latest available software (in my country)? Different by country, even the upgrade process?
But I also use now a different library (JTello) re-based to Processing and
everything works fine now. I haven't tested my own code yet. Will do that the upcoming weekend.

May u’re right... i’m gonna give u the last number here in Italy: 01.04.78.01... pls let me know if each country got different numbers... thanks a lot, pilot..!

 

[HawkLS]

According to Tello web page:

Ryze Tech

 

[DinoBaldi]

from Italy:
I confirm: 01.04.78.01

 

[Plissken]

Thanks a lot Dino...