mid:-1;x:0;y:0;z:0;mpry:0,0,0;pitch:0;roll:0;yaw:0;vgx:0;vgy:0;vgz:0;templ:50;temph:52;tof:10;h:0;bat:100;baro:683.53;time:0;agx:7.00;agy:-8.00;agz:-998.00;
mid:8;x:0;y:0;z:0;mpry:0,0,0;pitch:0;roll:0;yaw:0;vgx:0;vgy:0;vgz:0;templ:48;temph:50;tof:31;h:0;bat:100;baro:679.17;time:0;agx:-29.00;agy:-16.00;agz:-1001.00;
Hi I am new here. I just bought the tello for the video steaming with pythonCiao,
I'm having a LOT of problems with the new firmware,
- no more telemetry in Node-Red
- no video streaming with Python
luckily I have two Tello !
So I don't upgrade both....
Concerning the "new" function, I didn't find any....
Same Problem HereCiao,
I'm having a LOT of problems with the new firmware,
- no more telemetry in Node-Red
- no video streaming with Python
luckily I have two Tello !
So I don't upgrade both....
Concerning the "new" function, I didn't find any....
Same Problem Hereany possible resolution
Updated to 01.04.78.01 firmware this afternoon. First flight she was like a completely different bird, unstable fight, controller response variable, sometimes just moving up and down a foot or so when hovering( Not in bounce mode lol)
Did reset then IMU calibration followed by centre of gravity calibration, which has resulted in nice stable flight.
One difference I have noticed is whenever I get within 6 feet from my home router there is a little instability until I move Tello away from router. I wasn’t getting this before the update, some users report better range so maybe the receiver sensitivity has been increased.
Hope to try outside tomorrow morning, with luck all will be okay ??
Guess I was wrong about recalibration solving the problem. She is now intermittently unstable, just a few times each flight, I’ve also noticed that she climbs when moving forward. See video showing instability, bit difficult to control Tello and video with phone at the same time so all video examples are showing Tello when she should be hovering. Have sent the video to Ryze support, looking forward to their response.
I edited the footage to keep it short because no one wants to watch 10 minutes of video, she was climbing and descending after a little steady hovering. It also climbs flying forward when it’s not over obstacles. Will keep trying the calibration though, could get luckyThe cello flies low over the obstacles, so it rises to altitude, try to redo the whole IMU calibration and the center of gravity.
I only say what I think ..![]()
I just have to tell you try again to redo the two phases of calibration IMU and Gravity.I edited the footage to keep it short because no one wants to watch 10 minutes of video, she was climbing and descending after a little steady hovering. It also climbs flying forward when it’s not over obstacles. Will keep trying the calibration though, could get lucky
![]()
the center of gravity calibration is only active when the cello is stationary in flight.How do I calibrate gravity? The app shows that option as gray not blue...
We use essential cookies to make this site work, and optional cookies to enhance your experience.