Ya would like to think so. Assuming my adapter (total of 2.4A) gives 1.2A to the hub and drone. The batteries charging procedures always completed normally. Under amperage (not too low) seem to charge just fine. I start flying with full capacity all the time as indicated by the official app. I saw this post mentioning error code 13 popping up when the fall occurs. Mine did not prompt any error both times the fall occurred and I could restart and fly immediately.Lame excuse. Whatever it is this has nothing to do with charging. "under amperage" charging is good up to some point, it does less harm than high amp charging, and saturates the lipo better.
How to extract and read log file of tello on official app?For an error code to show up the drone must identify the problem, put the sticker "13" to it, save that sticker to its internal logfile, which is batched for a few ms (IIRC it every 200ms) and then sent to the phone. In the meantime some other circuit or routine might have decided to cut power immediately.
Sometimes error message will just not make it to your phone.
You might find evidence of the problem in the logfiles (like quickly dropping voltage levels), but to dissect them is a bit effort.
Thx. Will check it out.The info how to do this is spread over a few threads in this forum. I think here is also a YT video how to do this but I never checked it out.
I don't care, I don't use that app anymore .